- Monday - Friday : 8.30 AM - 5.30 PM
LCRonix – High Density and Precision LCR Meas System
- Home
- LCRonix - High Density and Precision LCR Meas System
Connect with Us
Have questions or need assistance?
Reach out to Emerix today for expert support and detailed information about our products and services.
LCRonix is designed for high-density interconnects and precise electrical verification of components on substrate.
Key Specification Breakdown
High Density Board
Extream accurate measurement of target components with minimal influence from surrounding parts, including MLCC devices in densely populated PCB layouts can be tested.
Test Type (Point to Point)
This indicates the machine uses probes to contact specific nodes on a PCB to measure the electrical path between them (L,C,R,D // Connectors // ICs)
Pitch (0.1mm)
With an extraordinary 0.1mm pitch, the system easily handles the challenges of 01005 (0402 mm) packages and high-density designs, ensuring reliable testing even when pads are crowded together.
Accuracy (0.05mm)
The mechanical positioning system is accurate to 50 microns, ensuring the probes hit the center of those tiny 0.1mm pitch targets without shorting adjacent pads.
Vision Test
Vision inspection for all component.
Floating Board Test
Ability to test on floating board
( double side tape board ) measuring L,C,R,D.
Solder Board
Ability to test L, C,R,D after the SMT process.
L, C, R, D Check
The system measures Inductance (L),Capacitance (C), and Resistance (R), Diode (D) to verify that the correct components are populated and functioning within tolerance.
Fully Automatic
No manual probing is required; the system moves the heads based on a programmed coordinate map.
Program Generation (10min)
This is a very fast setup time for generate program
WHY THESE SPECS MATTER
In modern electronics manufacturing (like smartphones or medical devices), components are shrinking to a point where human inspection is impossible.
-
A system with a 0.1mm pitch capability is essential for:
Detecting "Invisible" Shorts: Finding solder bridges that are too small for the naked eye. -
Verifying Passive Components:
Ensuring a 1nF capacitor wasn't accidentally swapped with a 10nF capacitor during assembly. -
High-Speed Prototyping:
Since it only takes 10 minutes to generate a program, you can test a new board design almost immediately after it's built.
Explore Now
Your Testing Solution is Here!
Explore the Emerix Board Test Application today. Designed for precision and efficiency, our application offers cutting-edge features that streamline your workflow and enhance testing accuracy.